Parking Brake Actuator With Control Unit for BMW E70 X5 E71 X6 34436850289 Fast

Description

Parking Brake Actuator With Control Unit for BMW E70 X5 E71 X6 34436850289 Fast
Parking Brake Actuator with Control Unit 34436850289 for BMW X5 X6 E70 E71 E72
Description:
Condition: Remanufactured
Type:Parking Brake Actuator With Control Unit
Replaces Part Number:34436850289,34 43 6 850 289
Compatible with the Following Models:
For BMW 2007-2013 X5 E70
For BMW 2008-2014 X6 E71 E72
Handbrake installation steps:
1) Check the degree of wear on the skin of the handbrake. If the wear is serious, it is recommended to change the hand brake skin first. (Note: handbrake skin, not foot brake skin)
2) Install the handbrake cable and adjust the gap between the handbrake and the brake drum as small as possible.
3) Plug in the computer plug, open the phone key door, check if the electronic handbrake module works normally (the second and third steps must not be reversed)
4) If the electronic handbrake template works normally, finally install the emergency unlocking line.
Notice:
1.Do not pull the emergency unlocking line at any time, unless the handbrake template is damaged, can't be removed, pull the emergency unlocking line, and the hand brake computer cannot continue to use after hearing the “kaba” sound.
2.If some fault codes cannot be cleared, drive a circle of approximately 5 to 10 kilometers, then go back, stop the fire, try again, and some fault codes will be automatically deleted.
Package Included:
1 x Parking Brake Actuator
Note:
Please check the pictures of this item and compare it with your part number carefully before you purchase!!!
Due to the different display and different light, the picture may not reflect the actual color of the item.
A: Why do you want to adjust the gap between the handbrake blades?
Most of EPB(EMF) need to be replaced because they are stuck. Fault code is emergency unlock and internal motor failure most of this fault is the handbrake disc gap caused by too large.you have to adjust the clearance.
B: How to adjust the clearance?
Tighten until the wheels not move.
Back up 3-4 teeth. don't warry about brake disc rubbing a little. EMF(EPB)automatically adjust.
The clearance of the two wheels remain the same.
C: What happens if you don't adjust the clearance?
Two wheels with different clearances can by noisy.
Large clearance motor tavel the motor runs long. fault code will be reported emergency unlock and internal motor failure stuck.